by Dremel ®
Tools & Accessories
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
Begin by placing paper on the charger and tracing the inner circle with a marker to guide you when cutting it out. Tape it to the part of the charger you do not want to paint.
Remove the paper to give you a perfect ring of paint on the outside of the charger.
Lastly, draw a pattern onto the charger. Then, use the Dremel rotary tool and bit to etch the pattern into the charger. Use the side of the accessory rather than the tip for effective engraving. Create a variety of plate chargers and use them at your Thanksgiving table this year!
Rotary Tool - How-ToCarving Pumpkins with a Dremel Cordless Rotary Tool
Saw - How-ToHow To Flush Cut Baseboard
Saw - DIYReplacing Ceramic Floor Tile
Saw - DIYHow to Replace Damaged Plywood Subfloor