by Dremel ®
Tools & Accessories
1Stain and Paintbrush (if desired)
1Floating Shelf (Available at major home improvement stores)
1Dremel MM14 Hook and Loop Pad
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
Once you have measured the length of the front and side borders of the floating your shelves, mark your line of cut on the moulding. Do not apply moulding to the back of your shelf, as it will need to rest flush against the wall. We chose to miter cut the moulding to give the edges of the shelf a nice, finished look. Fit your Dremel Saw-Max tool with a SM600 Wood and Plastic Flush Cutting Wheel. Once you have measured the length of cut you will need, rest your miter guide, 45 degree angled edge above the mould mark your cut. Now, slide the guide back just slightly, leaving 1/8" of space between your intended cut and the guide to account for the offset of the blade. Clamp the guide down and make your cut.
Using wood glue, set your pieces into place and allow them to dry thoroughly before mounting. We chose to stain ours as well!
We applied casing to the front and sides of our shelf and added a scalloped finish to the front. To cut the casing, use the Dremel Saw-Max and a SM600 Wood and Plastic Flush Cutting wheel. Once you have measured the length of cut you will need, rest your miter guide, straight edge above the mould mark your cut. Now, slide the guide back just slightly, leaving 1/8" of space between your intended cut and the guide to account for the offset of the blade. Clamp the guide down and make your cut.
Clamp your freshly cut casing onto a work bench. Use a pencil to draw out your desired design. Here, we went with a simple scallop. Mount a TR561 Multi-Purpose cutting bit into your Trio Tool. Set the tool to high speed and slowly cut along your marked line. The Trio tool should give you a nice, smooth cut. However, we decided to go the extra mile and smooth down our scallops with the MM20 tool and Wood Sandpaper.
Glue your casing onto the shelf and allow to dry completely before mounting.
We used extra small tiles leftover from a different project to create a mosaic-style shelf. Make sure to layout your design first to be sure you have enough tiles to achieve your desired look. We needed to make several cuts to get our layout to fit our shelf but it was easy! Mount the EZ545 Tile Cutting Wheel onto your variable speed Rotary Tool. Please note that this wheel should not run in excess of 20,000 RPM, therefore, do not use this wheel with a single -speed tool. We used a 4000 tool here. With our 4000 tool set to a speed setting of 15, we cut off the areas of our tiles which did not fit our layout.
Glue the tiles into place. Here, we used hot glue. Allow to dry completely and mount it to your wall!
A TOOL THAT CAN DO IT ALL
Experience Dremel's most powerful oscillating tool. Featuring 7.0 amps of power and 2 new, powerful cutting blades, the Dremel Velocity is the only tool you need.
SHOW US WHAT YOU MADE
Send us a photo of your Dremel creation so we can share it with the world.