by Dremel ®
14.5" terracotta pot
14.75" terracotta saucer
16.5" terracotta saucer
16" length 3/8" threaded rod or eyebolt
1Complimentary nut (2 nuts if you use threaded rod) & washer
1Face mask: cutting terracotta can be dusty!
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
The large saucer serves as the birdhouse roof & the small saucer will serve as the perch underneath the feeder. Insert a Dremel 562 tile cutting bit into your High-Performance Rotary Tool (we used our 8220 tool). Set your tool to high speed and grind a 3/8-inch hole in the center of each saucer. Tip: Most terracotta pots have drainage holes at the bottom center. If your pot doesn't have a drainage hole or if the hole needs to be made larger, you can use your Dremel tool with the 562 bit to do so!
Next, draw out your desired deisgn onto the pot. Through this design, seeds will be accessible to your feathered visitors! Make sure you choose a design that will allow enough accessiblity to the seeds without causing them all to empty onto the perch. Using your Dremel Rotary Tool equipped with the 562 Tile Cutting Bit, set your tool to high speed to grind through your design, making several light plunging motions.
Thread all components together to form the hanging house: Set your pot on top of the large saucer& cap the pot off with the smaller saucer. Thread a 5" rod or eyebolt through the holes on all three pieces. (If you choose to use a threaded rod, be sure to secure a bolt at the top of your threaded rod at this step). Flip your pot upside-down and set the large saucer on top of the pot. Thread the washer onto the rod & secure the nut 1/2" onto the rod. To fill your pot with seeds, simply loosen the bottom of the feeder, holding the pot at an angle and fill! To hang your feeder with twine as we have done, secure your desired length to the top of the eye bolt with a square knot. You may want to add a dab of hot glue for an extra-secure knot.
Rotary Tool - DIYSharpening a Chainsaw
Rotary Tool - How-ToCarving Pumpkins with a Dremel Cordless Rotary Tool
Saw - How-ToHow To Flush Cut Baseboard
Saw - DIYReplacing Ceramic Floor Tile
A TOOL THAT CAN DO IT ALL
Experience Dremel's most powerful oscillating tool. Featuring 7.0 amps of power and 2 new, powerful cutting blades, the Dremel Velocity is the only tool you need.
SHOW US WHAT YOU MADE
Send us a photo of your Dremel creation so we can share it with the world.